IMPORTANT! If using PCI cards on shared slots, make sure that the drivers
2-6 Connectors, Headers
2-6-1 Connectors
(1)
Power Connector: ATX (20-pin block)
ATX Power Supply connector. This is a new defined 20-pins connector that
usually comes with ATX case. The ATX Power Supply allows to use soft power
on momentary switch that connect from the front panel switch to 2-pins Power
On jumper pole on the motherboard. When the power switch on the back of the
ATX power supply turned on, the full power will not come into the system board
until the front panel switch is momentarily pressed. Press this switch again will
turn off the power to the system board.
(2)
PS/2 Mouse & PS/2 Keyboard Connector: KB/MOUSE
The connectors for PS/2 keyboard and PS/2 Mouse.
(3)
USB Port connector: USB
The connectors are 4-pins connector that connect USB devices to the system board.
support "Shared IRQ" or that the cards don't need IRQ assignments.
Conflicts will arise between the two PCI groups that will make
the system unstable or cards inoperable.
16