Pm Wake Up Events - JETWAY K8M8M - REV 3.0 User Manual

DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
The settings are: Delay 4 Sec, Instant-Off.
Wake Up Events
Please refer to section 3-8-1
3-8-1 Wake up Events
VGA
LPT & COM
HDD & FDD
PCI Master
Wake-Up on PCI PME
PS2 KB Wake up Selection
Wake-Up on Hot Key (PS2 KB)
Wake-Up on USB Device
Wake-Up on RTC Alarm
Date of Month Alarm
Time (hh:mm:ss) Alarm
> IRQs Activities
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Wake Up On Ring/PME
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from the modem.
Wake-Up on RTC Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.
IRQs Activities
Please refer to section 3-8-1.1
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
Phoenix – AwardBIOS CMOS Setup Utility
Wake Up Events
OFF
LPT/COM
ON
OFF
Disabled
Hot Key
Disabled
Disabled
Disabled
0
0 : 0 : 0
Press Enter
F6:Optimized Defaults
Menu Level >>
F7:Standard Defaults
30
Item Help
F1:General Help