Pm Wake Up Events - JETWAY 849BS User Manual

ACPI function
Video Off Option
Video Off Method
MODEM Use IRQ
Power Button Function
> PM Wake Up Events
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
ACPI Function
This item allows you to Enabled/Disabled the Advanced Configuration and Power Management
(ACPI). The settings are Enabled and Disabled.
Video Off Option
This determines the manner in which the monitor is blanked. The choice are Suspend  off,
All Modes  Off, and Always On.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.

PM Wake Up Events

Please refer to section 3-8-1
3-8-1 PM Wake Up Events
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
Wake-Up on PCI PME
Wake-Up on Ring/(LAN)
Power Management Setup
Enabled
Always off
V/H SYNC+Blank
3
Instant Off
Press Enter
F6:Optimized Defaults
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
PM Wake Up Events
Disabled
Disabled
34
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults
Item Help