3-8-1.1 Irqs Activities; Pnp/Pci Configuration Setup - JETWAY K8M8M - REV 3.0 User Manual

3-8-1.1 IRQs Activities

Primary INTR
IRQ3 (COM 2)
IRQ4 (COM 1)
IRQ5 (LPT 2)
IRQ6 (Floppy Disk)
IRQ7 (LPT 1)
IRQ8 (RTC Alarm)
IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values

3-9 PnP/PCI Configuration Setup

This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
PnP OS Installed
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system can not boot. The
settings are: Enabled and Disabled.
Phoenix – AwardBIOS CMOS Setup Utility
IRQs Activities
ON
Disabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Enabled
Enabled
Enabled
Disabled
F6:Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
No
Disabled
Manual
Press Enter
Disabled
F6:Optimized Defaults
Menu Level >>>
F7:Standard Defaults
Menu Level >
F7:Standard Defaults
31
Item Help
F1:General Help
Item Help
F1:General Help