JETWAY 993AN User Manual page 31

-12V Low Limit/High Limit
These values are used to specify the threshold values of detecting the abnormal condition of ,
3.3V, +5V, +12V, -12V.
2. FAN Speed
CPUFAN/ SYSFAN
If the fan RPM is lower than this value and "CPUFAN/SYSFAN" is enabled in Monitoring
Config. the PC Speaker will alarm and the monitor software will pop up a window to inform
user.
3. Temperature
System/ CPU Low Limit/ High Limit
There values is used to specify the Temp-Over register/ Tem-under register of PC HEALTH
MONITOR CHIP, If the temperature of the external thermistor is higher than this value and
"System/CPU" is enabled in Monitoring Config. the monitor software will pop up a window to
inform user.
Monitoring Config.
Enabled or Disabled: User can decide which item should be monitored or not by choosing the
Faults Count (1 or 3): User can decide the system to pop up the warning message when there
Beep:
4-3 Sound Driver & Audio Rack Installation( Option for Motherboard
That Embedded PC Health Chip ) :
item in the configuration page.
is 1 fault detected or there are 3 consecutive faults detected.
In addition to pop up warning message user can choose to activate Beep
tone if there is error detected. Beep tone will until the error is treated.
29