JETWAY 920BFR3A User Manual page 23

Enabled: Floppy A & B will be swapped under the DOS
Disabled: Floppy A & B will be not swap
•
Boot Up Floppy Seek:
installed is 40 or 80 tracks. 360K type is 40 tracks while 760K, 1.2M and 1.44M are all 80
tracks. The default value is Enabled.
Enabled: BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks.
Note that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are
all 80 tracks.
Disabled: BIOS will not search for the type of floppy disk drive by track number.
Note that there will not be any warning message if the drive installed is 360K.
•
Boot Up NumLock Status: The default value is On.
On: Keypad is number keys.
Off: Keypad is arrow keys.
•
Boot UP System Speed: It selects the default system speed-the speed that the system
will run at immediately after power up.
High: Set the speed to high.
Low: Set the speed to low.
NOTE: The board default value is LOW in the field. Boot the system to controller turbo or De-turbo
by Onboard (Turbo Switch).
•
Typematic Rate Setting: This determines the typematic rate.
Enabled: Enable typematic rate and typematic delay programming.
Disabled: Disable typematic rate and typematic delay programming. The system BIOS
will use default value of this 2 items and the default is controlled by keyboard.
•
Typematic Rate (Chars/Sec):
6 : 6 characters per second
10 : 10 characters per second
15 : 15 characters per second
24 : 24 characters per second
•
Typematic Delay (Msec): When holding a key, the time between the first and second
character displayed.
250 : 250 msec
500 : 500 msec
750 : 750 msec
1000 : 1000 msec
•
Security Option: This category allows you to limit access to the system and Setup, or
just to Setup. The default value is Setup.
System: The system will not boot and access to Setup will be denied if the correct
password is not entered at the prompt.
Setup: The system will boot, but access to Setup will be denied if the incorrect
password is entered at the prompt.
NOTE: To disable security, select PASSWORD SETTING at Main Menu and then you will be
asked to enter password. Do not type anything and just press <Enter>, it will disable
security. Once the security is disabled, the system will boot and you can enter Setup freely.
•
Video BIOS Shadow: It determines whether video BIOS will be copied to RAM, however,
it is optional from chipset design. Video Shadow will increase the video speed.
During POST, BIOS will determine if the floppy disk drive
8 : 8 characters per second
12 : 12 characters per second
20 : 20 characters per second
30 : 30 characters per second
21