JETWAY 920BFR3A User Manual page 32

step1: Run "X:\SiS620\HEALTH\SETUP.EXE" file .
step2: Selet "Next" to complete install driver.
step3: The program will automatic install driver to system if users have
question in system Hardware Monitor Setting, please read "HELP"
Section in program.
4-2 Sound Driver & Audio Rack Installation( Option for
Motherboard That Embedded Audio Chip ) :
Special Features for CMI8738 audio chip
PCI Plug and Play (PnP) bus interface, 32 bit PCI bus master.
Full duplex playback and recording, built-in 16 bits CODEC.
HRTF 3D positional audio, supports both Direct Sound 3D ® & A3D® interfaces, supports
earphones, two and four channel speakers mode.
Support Windows 3.1 / 95 / 98 and Windows NT 4.0.
Built-in 32 OHM Earphone buffer and 3D surround.
MPU-401 Game/Midi port and legacy audio SB16 support.
Downloadable Wave Table Synthesizer, supports Direct Music®.
• Digital Audio (SPDIF IN/OUT)
Up to 24 bit stereo 44KHz sampling rate voice playback/recording.
Full duplex playback and recording, 120dB audio quality measured.
Auto detectable SPDIF/IN signal level from 0.5V to 5V.
• Stereo Mixer and FM Music Synthesizer
Stereo analog mixing from CD-Audio, Line-in
Stereo digital mixing from Voice, FM/Wave-table, Digital CD-Audio
Mono mixing from MIC and software adjustable volume
OPL3 FM synthesizer (4 operators)
Up to 15 melody sounds and 5 rhythm sounds (20 voices)
• Game and Midi Interface
Fully compatible with MPU-401 Midi UART and Sound Blaster Midi
mode/ Standard IBM PC joystick/game port (dual channels)
DOS Installation
Before beginning the installation, please make sure that your hard disk has sufficient
space(min. 4MB). Insert the Driver CD into the CD-ROM Drive.
1. Change directory to PCI audio DOS drivers folder (ex. X:\CMI8738\DOSDRV) at DOS
prompt, and type:
INSTALL [Enter]
2. Type DOS utilities path which you want to install.
3. Program will expand the file to the path which you've specified.
4. Install program will add initial drivers into AUTOEXEC.BAT file.
Win95/98 Installation
We recommend that you install Microsoft Windows before you install this PCI sound card,
and you not install any other sound card device drivers in your current system.
1. Turn on the computer , and enter the Microsoft Windows 95/98
2. Before install sound card driver please double-click "My Computer" icon, "Control Panel"
icon , "System" icon, and choose "Device Manager" item.
3. Check "Other Device" item ,if there have "PCI Multimedia Audio Device", please remove
it first ,and Restart System again.
4. You will see a windows prompt like this:
"New Hardware Found PCI Multimedia Audio Device Windows has found new hardware
and is installing the software for it" , then the dialog box shown Click "Next" button to go on.
5. Click "Other Locations" button to specify drivers path:
" X:\CMI8738\Win9X\DRV"
6. Select "OK" to finish install.
7. Now, system is installing device drivers automatically. After a while, the system will finish the
30