(11) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(12) Primary IDE Connector (40-pin block): IDE1 (Support ATA 100)
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
Line-IN
PS/2
PRINT
Mouse
COM1 VGA/COM2
PS/2
Keyboard
FDD
Floppy Drive Connector
IDE1
23
Line-OUT
Surrback
USB2
GEN/LFE
Pin 1
Pin 1
LAN
USB
MIC-IN
SURROUND