Table of Contents
Advertisement
When you install DIMM module fully into the DIMM socket the eject tab
NOTE!
should be locked into the DIMM module very firmly and fit into its indention
on both sides.
2-5 Expansion Cards
WARNING! Turn off your power when adding or removing expansion cards or other system
components. Failure to do so may cause severe damage to both your motherboard
and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1. Read the documentation for your expansion card and make any necessary hardware or
software setting for your expansion card such as jumpers.
2. Remove your computer's cover and the bracket plate on the slot you intend to use.
3. Align the card's connectors and press firmly.
4. Secure the card on the slot with the screen you remove above.
5. Replace the computer system's cover.
6. Set up the BIOS if necessary.
7. Install the necessary software driver for your expansion card.
DIMM1 & DIMM3: Dual Channel 1 for DDR2
DIMM2 & DIMM4: Dual Channel 2 for DDR
19
Figure 2-4
Advertisement
Table of Contents
