Miscellaneous Control; Load Standard/Optimized Defaults; Set Supervisor/User Password - JETWAY 830CF User Manual

M/b for socket-a athlon/duron processor

Hide thumbs Also See for 830CF:

User manual (57 pages)

Table Of Contents

Table of Contents

This section is for setting CPU Frequency Control.

Auto Detect DIMM/PCI Clk

Spread Spectrum

Clock Control

** Current Host Clock is 100 MHz **

HOST clock at next boot is 100 Mhz

** Current DRAM Clock is 100 MHz **

DRAM clock at next boot is 100 Mhz (HOST CLK)

↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit

F5:Previous Values

Auto Detect DIMM/PCI Clk

This item allows you to enable/disable auto detect DIMM/PCI Clock.

The settings are: Enabled, Disabled.

Clock Control

This item allows you to set the CPU Host Clock by Hardware (Jumper S1), or by Software

(BIOS)

Host clock at next boot is

When Clock Control setting By Software this item allows you to set CPU Host Clock step by

step from 100MHz to 166MHz, use Page Down/Page Up key can change the frequency to

approach over clocking.

DRAM clock at next boot is

This item allows you to set the DRAM clock synchronous as CPU Host Clock or

Asynchronous as Host clock *4/3 to approach your SDRAM specification.

3-12 Load Standard/Optimized Defaults

Load Standard Defaults

When you press <Enter> on this item, you get confirmation dialog box with a message similar

to:

Load Standard Defaults (Y/N)? N

Pressing <Y> loads the BIOS default values for the most stable, minimal-performance system

operations.

Load Optimized Defaults

When you press <Enter> on this item, you get a confirmation dialog box with a message

similar to:

Load Optimized Defaults (Y/N)? N

Pressing <Y> loads the default values that are factory settings for optimal performance system

operations.

3-13 Set Supervisor/User Password