Table of Contents
Advertisement
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow
the same procedure described for the primary IDE connector. You may also
configure two hard disks to be both Masters using one ribbon cable on the
primary IDE connector and another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to
as the "Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or
DVD-ROM drive on the same IDE channel as a hard disk. Otherwise, the system
performance on this channel may drop.
2-6-2 Headers
(1)
COM2 Headers (9-pin block): COM2
This board has another serial port COM2, it come with cable providing serial
port COM2.
(2)
USB Port Headers (9-pin block): USB1
Pin 1
Primary IDE Connector
Secondary IDE Connector
Pin 1
Note: Orient the read marking on the
Pin 1
COM2
19
COM2 ribbon cable to pin 1
Hide quick links:
Advertisement
Table of Contents
