Install Memory - JETWAY 830CF User Manual

This section is for experienced motherboard installer only. Over
WARNING!
clocking can result in system instability or even shortening life of
the processor.
After setting the Jumper
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose "Miscellaneous
Control" you will see the screen as below, when setting clock control by software, you
can setting Host Clock step by step in Host Clock at next boot from 100MHz to
166MHz for user approach over clock running.
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Auto Detect DIMM/PCI Clk
Spread Spectrum
Clock Control
** Current Host Clock is 100 MHz **
HOST clock at next boot is 100 Mhz
** Current DRAM Clock is 100 MHz **
DRAM clock at next boot is 100 Mhz (HOST CLK)
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Clock Control
This item allows you to set the CPU Host Clock by Hardware (Jumper S1), or by Software
(BIOS)
Host clock at next boot is
When Clock Control setting By Software, this item allows you to set CPU Host Clock step by
step from 100MHz to 166MHz, use Page Down/Page Up key can change the frequency to
approach over clocking.
DRAM clock at next boot is
This item allows you to set the DRAM clock synchronous as CPU Host Clock, or
Asynchronous as Host clock *4/3 to approach your SDRAM specification.

2-4 Install Memory

S1 you can choose over clock running by BIOS CMOS
Miscellaneous Control
Enabled
Disabled
By Software
F6:Optimized Defaults F7:Standard Defaults
12
Item Help
Menu Level >
F1:General Help