AMX 10.4 TOUCH PANELS (G3 FIRMWARE) Instruction Manual page 9

FIG. 3 Decor style (AXD) and CB-TP3 cutout dimensions (solid surfaces)
2.
Carefully insert a flat-blade screwdriver into the release slot on the touch panel's bezel and
remove the engraved overlay.
3. Lay the touch panel facedown on a soft cloth and remove the screws from the low-profile
Backbox; remove the Backbox and discard.
4. Place the CB-TP3 into the cutout and mark the threaded insert positions, as shown in FIG. 3.
The CB-TP3 can also be mounted to wood or metal studs using the pre-drilled stud
mounting holes.
5. Remove the CB-TP3 and drill eight holes (A and B) for the panel (FIG. 3). Then, place #6-32
threaded inserts (or screw anchors) into the four holes marked 'B' (FIG. 3).
6. Disconnect the AXlink connector from the Central Controller, RS-232 connector, and the
optional graphic/video wiring from the source equipment.
7. Remove one or more knockouts to accommodate the wiring.
8. Thread the incoming AXlink, RS-232, and optional graphic/video wiring through the CB-TP3
knockouts. Refer to the Wiring the Touch Panel section on page 8 for pinout descriptions.
10.4" Touch Panels
Installation
5