AMX 10.4 TOUCH PANELS (G3 FIRMWARE) Instruction Manual page 31

Serial Commands (Cont.)
SET CAL
Sets the calibra-
tion variables.
SETUP
Puts the touch
panel on the
Setup Page.
VER
Restores the cur-
rent version.
WORKING?
Verifies the com-
munication
between the touch
panel and the Ter-
minal Emulator.
ZAP!
Clears all mem-
ory.
Only use the ZAP! command to erase the saved data in the touch panel; data cannot be
recovered after it is erased.
10.4" Touch Panels
Syntax:
"SET CAL <X Multiplier> <X Offset> <Y Multiplier> <Y
Offset>"
Example:
SET CAL 2F 3A 2B 62
Sets the calibration values on the touch panel.
Syntax:
"SETUP"
Example:
SETUP
Flips the touch panel to the Setup page.
Syntax:
"VER"
Example:
VER
Returns the current version of the main firmware.
Syntax:
"WORKING?"
Example:
WORKING?
Response:
$SC 1,"'CPAGE72-Main Page'"
Responding touch panel turns its Main page the color white. This command verifies serial
communication. The 10.4" panel must have a page named Main Page for this command to
work properly.
Syntax:
"ZAP!"
Example:
ZAP!
Clears all memory and erases all buttons, pages, drawings, and symbols.
Programming
27