Radio Shack 63-1110 - Wireless Mail Guard Owner's Manual page 6

63-1110.fm Page 6 Friday, September 22, 2000 3:33 PM
2. Loosen the screw on the battery retaining clip,
then slide the clip aside.
3. Install the two supplied CR 2032 batteries in the
compartment with their positive (+) sides facing
up.
4. Slide the battery retaining clip over the center of
the top battery and tighten its screw.
5. Use a small pointed
object (such as
straightened paper
clip) to slide
A B C
the desired channel
and set Low/Hi to the
desired light sensitiv-
ity. (Factory setting is
channel with sen-
B Hi
sitivity.)
6. Make sure the black o-ring remains secure
around the transmitter's top cabinet, then replace
the transmitter's bottom cabinet.
7. Tighten the transmitter's screws.
6
Installation
A B C Channel Switch
a
to
Low Hi Sensitivity Switch