Connecting Ac Power - Radio Shack 63-1110 - Wireless Mail Guard Owner's Manual

63-1110.fm Page 12 Friday, September 22, 2000 3:33 PM
To mount the base (receiver) on a wall, you need two
screws (not supplied) with heads that fit into the key-
hole slots on the back of the base.
1. Drill two horizontal pilot holes into the mounting
surface, 3 inches (76 mm) apart.
2. Thread a screw into each hole until the screw's
head extends about
3. Align the keyhole slots on the bottom of the base
with the screw heads, then slide the base down
to secure it.

CONNECTING AC POWER

Power the base (receiver) using the supplied 12V,
200 mA AC adapter.
12
Installation
1
/ inch from the wall.
4