Table of Contents
Advertisement
Chapter 5
Administering the Bridge
Command
Step 3
aaa authentication login {default |
list-name} method1 [method2...]
Step 4
line [console | tty | vty] line-number
[ending-line-number]
Step 5
login authentication {default |
list-name}
Step 6
end
Step 7
show running-config
Step 8
copy running-config startup-config
To disable AAA, use the no aaa new-model global configuration command. To disable AAA
authentication, use the no aaa authentication login {default | list-name} method1 [method2...] global
configuration command. To either disable RADIUS authentication for logins or to return to the default
value, use the no login authentication {default | list-name} line configuration command.
Defining AAA Server Groups
You can configure the bridge to use AAA server groups to group existing server hosts for authentication.
You select a subset of the configured server hosts and use them for a particular service. The server group
is used with a global server-host list, which lists the IP addresses of the selected server hosts.
Server groups also can include multiple host entries for the same server if each entry has a unique
identifier (the combination of the IP address and UDP port number), allowing different ports to be
individually defined as RADIUS hosts providing a specific AAA service. If you configure two different
host entries on the same RADIUS server for the same service (such as accounting), the second
configured host entry acts as a fail-over backup to the first one.
OL-4059-01
Purpose
Create a login authentication method list.
•
To create a default list that is used when a named list is not specified
in the login authentication command, use the default keyword
followed by the methods that are to be used in default situations. The
default method list is automatically applied to all interfaces.
For list-name, specify a character string to name the list you are
•
creating.
For method1..., specify the actual method the authentication
•
algorithm tries. The additional methods of authentication are used
only if the previous method returns an error, not if it fails.
Select one of these methods:
local—Use the local username database for authentication. You must
•
enter username information in the database. Use the username
password global configuration command.
•
radius—Use RADIUS authentication. You must configure the
RADIUS server before you can use this authentication method. For
more information, see the
section on page
11-4.
Enter line configuration mode, and configure the lines to which you want
to apply the authentication list.
Apply the authentication list to a line or set of lines.
If you specify default, use the default list created with the aaa
•
authentication login command.
For list-name, specify the list created with the aaa authentication
•
login command.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
Controlling Bridge Access with RADIUS
"Identifying the RADIUS Server Host"
5-9
Advertisement
Table of Contents
