Clearing Configuration Information; Deleting A Stored Configuration File - Cisco CISCO1401 - 1401 Router - EN Software Manual

Working with Configuration Files
Command
Step 5
end
Step 6
copy system:running-config
rcp:[[[//[username@]location]/directory]/filename]
or
copy nvram:startup-config
rcp:[[[//[username@]location]/directory]/filename]
This example shows how to copy the running configuration file named ap2-confg to the netadmin1
directory on the remote host with an IP address of 172.16.101.101:
BR# copy system:running-config rcp://netadmin1@172.16.101.101/ap2-confg
Write file br-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
BR#
This example shows how to store a startup configuration file on a server:
BR# configure terminal
BR(config)# ip rcmd remote-username netadmin2
BR(config)# end
BR# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [ap2-confg]?
Write file ap2-confg on host 172.16.101.101?[confirm]
![OK]

Clearing Configuration Information

This section describes how to clear configuration information.

Deleting a Stored Configuration File

You cannot restore a file after it has been deleted.
Caution
To delete a saved configuration from Flash memory, use the delete flash:filename privileged EXEC
command. Depending on the setting of the file prompt global configuration command, you might be
prompted for confirmation before you delete a file. By default, the bridge prompts for confirmation on
destructive file operations. For more information about the file prompt command, refer to the Cisco IOS
Command Reference for Release 12.1.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
17-18
Chapter 17
Purpose
Return to privileged EXEC mode.
Using RCP, copy the configuration file from an bridge
running or startup configuration file to a network server.
Managing Firmware and Configurations
OL-4059-01