Cw-Min And Cw-Max Settings For Point-To-Point And Point-To-Multipoint Bridge Links - Cisco CISCO1401 - 1401 Router - EN Software Manual

Chapter 13 Configuring QoS
Figure 13-2 Radio Traffic Classes Page

CW-min and CW-max Settings for Point-to-Point and Point-to-Multipoint Bridge Links

For best performance on your bridge links, adjust the CW-min and CW-max contention window settings
according to the values listed in
for point-to-point links. However, for point-to-multipoint links, you should adjust the settings depending
on the number of non-root bridges that associate to the root bridge.
Note
Table 13-2 CW-min and CW-max Settings for Point-to-Point and Point-to-Multipoint Bridge Links
Setting
CW-min
CW-max
OL-4059-01
Table
If packet concatenation is enabled, you need to adjust the CW-min and CW-max settings only
for traffic class 0. Concatenation is enabled by default.
Point-to-Point Links
3
10
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
13-2. The default settings, CW-min 3 and CW-max 10, are best
Point-to-Multipoint Point-to-Multipoint
Links with up to 5 Links with up to 10
Non-Root Bridges Non-Root Bridges
4 5
10 10
Configuring QoS
Point-to-Multipoint
Links with up to 17
Non-Root Bridges
6
10
13-9