Configuring Filters Using the Web-Browser Interface
Figure 14-4 Apply Filters Page
Select the filter name from one of the IP drop-down menus. You can apply the filter to either or both the
Step 17
Ethernet and radio ports, and to either or both incoming and outgoing packets.
Click Apply. The filter is enabled on the selected ports.
Step 18
Configuring and Enabling Ethertype Filters
Ethertype filters prevent or allow the use of specific protocols through the bridge's Ethernet and radio
ports. You can apply the filters you create to either or both the Ethernet and radio ports and to either or
both incoming and outgoing packets.
Use the Ethertype Filters page to create Ethertype filters for the bridge.
Filters page.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
14-8
Chapter 14
Configuring Filters
Figure 14-5
shows the Ethertype
OL-4059-01