Control Timer Values (Sec) Section - Cisco SPA2102-AN - Single Port Router Administration Manual

ATA Voice Field Reference
Regional page
Cisco Small Business ATA Administration Guide
CWT Frequency
Synchronized Ring
Voice tab > Regional page >

Control Timer Values (sec) section

Hook Flash Timer
Min
Hook Flash Timer
Max
Callee On Hook
Delay
Reorder Delay
Call Back Expires
Call Back Retry
Intvl
Frequency script of the call waiting tone. All distinctive
CWTs are based on this tone.
The default is 440@-10.
If this is set to Yes, when a device calls the Linksys ATA,
both lines ring at the same time (similar to a regular PSTN
line). After one line answers, the other stops ringing. This
field is only found in the PAP2T. No is the default.
Minimum on-hook time before off-hook qualifies as hook-
flash. Less than this the on-hook event is ignored. Range:
0. 1 –0.4 seconds.
The default is 0.1.
Maximum on-hook time before off-hook qualifies as hook-
flash. More than this the on-hook event is treated as on-
hook (no hook-flash event). Range: 0.4–1.6 seconds.
The default is 0.9.
Phone must be on-hook for at this time in sec before the
ATA device will tear down the current inbound call. It does
not apply to outbound calls. Range: 0–255 seconds.
The default is 0.
Delay after far end hangs up before reorder tone is played.
0 = plays immediately, inf = never plays. Range: 0–255
seconds.
The default is 5.
Expiration time in seconds of a call back activation. Range:
0–65535 seconds.
The default is 1800.
Call back retry interval in seconds. Range: 0–255 seconds.
The default is 30.
B
146