Advanced Configurations; Upgrading, Rebooting, And Resyncing Your Ata Device; Upgrade Url - Cisco SPA2102-AN - Single Port Router Administration Manual

Basic Administration and Configuration

Upgrading, Rebooting, and Resyncing Your ATA Device

Upgrading, Rebooting, and Resyncing Your ATA Device
NOTE
Cisco Small Business ATA Administration Guide

Advanced Configurations

Other parameters may need to be changed from the defaults, depending on the
requirements of a specific ITSP. Some of the commonly configured parameters
include the following:
• Streaming Audio Server—You can enable an external music source for music
on hold. See the "Configuring a Streaming Audio Server," on page 88
further information.
• NAT Settings—You can adjust these settings to resolve issues that arise when
using a ATA on a network behind a Network Address Translation (NAT) device.
See the "Network Address Translation (NAT) and Voice over IP (VoIP)," on
page 47 for further information.
• Subscriber Information—You can configure security parameters. See the
"Secure Call Implementation," on page 71
• Dial Plan—You can configure a dial plan for a specific line. See the
"Configuring Dial Plans," on page 61
The administration web server supports upgrading, rebooting, and resyncing
functions through special URLs. Administrator account privilege is needed for
these functions.

Upgrade URL

The Upgrade URL lets you upgrade the ATA device to the firmware specified by
the URL, which can identify either a TFTP or HTTP server.
Upgrade Enable
If the value of the
cannot upgrade the ATA device even if the web page indicates otherwise.
The syntax of the Upgrade URL is as follows:
http://spa-ip-addr/admin/upgrade?[protocol://][server-name[:port]][/
firmware-pathname]
Both HTTP and TFTP are supported for the upgrade operation.
for further information.
for further information.
parameter in the Provisioning page is No, you
2
for
43