Resync Url; Reboot Url - Cisco SPA2102-AN - Single Port Router Administration Manual

Basic Administration and Configuration
Upgrading, Rebooting, and Resyncing Your ATA Device
NOTE
NOTE
Cisco Small Business ATA Administration Guide
protocol
If no is specified, TFTP is assumed. If no
host that requests the URL is used as
If no port specified, the default port of the protocol is used. (69 for TFTP or 80 for
HTTP)
firmware-pathname
The
directory on the TFTP or HTTP server. If no
spa.bin
is assumed, as in the following example:
http://192.168.2.217/admin/upgrade?tftp://192.168.2.251/spa.bin

Resync URL

The Resync URL lets you force the ATA device to do a resync to a profile specified
in the URL, which can identify either a TFTP, HTTP, or HTTPS server. The syntax of
the Resync URL is as follows:
http://spa-ip-addr/admin/resync?[[protocol://][server-name[:port]]/profile-
pathname]
The SPA resyncs only when it is idle.
If no parameter follows
page is used.
protocol
If no is specified, TFTP is assumed. If no
host that requests the URL is used as
If no port is specified, the default port is used (69 for TFTP, 80 for HTTP, and 443
for HTTPS).
The profile-path is the path to the new profile with which to resync, for example:
http://192.168.2.217admin/resync?tftp://192.168.2.251/spaconf.cfg

Reboot URL

The Reboot URL lets you reboot the ATA device. The Reboot URL is as follows:
http://spa-ip-addr/admin/reboot
The ATA device reboots only when it is idle.
server-name
is typically the file name of the binary located in a
firmware-pathname
/resync?,
the Profile Rule setting from the Provisioning
server-name
server-name
is specified, the
.
is specified,
server-name
is specified, the
.
2
/
44