Setup 4: Connecting To Optional Audio Equipment - Toshiba SD-H400-S-TU Installation Manual

_ _ _ _ _ C_h_a_p __
t_e_f_3 -----' - _
~
Setup 4: Connecting to Optional Audio Equipment
24
Notes:
• DO NOT connect the BITSTREAMI
PCM (DIGITAL) AUDIO OUT jack of
the SD-H400 to the AC-3 RF input of a
Dolby Digital Receiver. This input on
your AIV Receiver is reserved for
Laserdisc use only and is incompatible
with the BITSTREAM/PCM (DIGITAL)
AUDIO OUT jack of the SD-H400.
• Connect the BITSTREAMIPCM
(DIGITAL) AUDIO OUT jack of the
SD-H400 to the "DIGITAL (OPTICAL)"
or "DIGITAL (COAXIAL)" input of a
Receiver or Processor.
• Refer to the owner's manual of the
connected equipment as well.
• Before connecting the SD-H400 to other
equipment, be sure to tum off the power
and unplug the SD-H400 and all
equipment it will connect to.
• The output sound of the SD-H400 has a
wide dynamic range. Be sure to adjust
the receiver's volume to a moderate
listening level. Otherwise, the speakers
may be damaged by a sudden high
volume spike.
• Tum offthe amplifier before you connect
or disconnect the SD-H400's power cord.
If you leave the amplifier power on, the
speakers may be damaged.
You can enjoy high quality dynamic sounds by cOIlllecting the SD-H400 to optional audio
equipment.
• For connection to your TV, see Setup I: Connecting to a TV and Optional VCR.
• For details of output sound, see the DVD Player Operation Guide.
• This section uses the following reference marks.
II :
Front speaker
IIIJ :
Rear speaker
[ ] : Sub Woofer
[lI :
Centre speaker
• : Signal Flow
Warning:
When you are connecting (via the BITSTREAMIPCM (DIGITAL) AUDIO OUT jack) an AV
decoder that does not have Dolby Digital or MPEG2 decoding function, be sure to set "Digital
Output" to "PCM" from the on-screen displays. Otherwise, high volume sound may damage
your hearing as well as the speakers.
DO NOT play DTS-encoded discs when you are connecting an AV decoder that does not have
DTS decoding function.
When playing DTS-encoded discs (audio CDs), excessive noise may be output from the
analog audio output jacks. To avoid possible damage to the audio system, you should take
proper precautions when the analog audio output jacks of the SD-H400 are connected to an
amplification system. To enjoy DTS Digital Surround™ playback, an externalS.! channel
DTS Digital Surround™ decoder system must be connected to the BITSTREAMlPCM
(DIGITAL) AUDIO OUT jack of the SD-H400.