Delta 36-714 Instruction Manual page 14

ADJUSTING TABLE INSERT
Disconnect the machine from the power source!
Make sure that the table insert (A) is always
level with the table.
Place a straight edge (B) Fig. 30 across the table at both
ends of the table insert (A).
To adjust, loosen the screw (D) Fig. 30 and turn the adjusting
screws (C) Fig. 29 with the supplied hex wrench.
INSTALLING THE TOOL HOLDERS
Disconnect the machine from the power source!
Install the fence holders (A) Fig. 31 using four M4 8mm self-tapping screws (4).
Install the wrench hook (B) using two M4 x 8mm self-tapping screws.
Install the miter gauge holder (C) Fig. 32 underneath the motor cover on the right side of the saw using four M4 x 8mm self-
tapping screws.
INSTALLING DUST PORT
Disconnect the machine from the power source!
Attach the dust port (D) Fig. 33 using four 1/4-20 x 3/8"
self-tapping screws.
ASSEMBLING THE MITER GAUGE
Disconnect the machine from the power source!
Place a flat washer (A) Fig 34 on the threads of the miter
gauge lock handle (B). Thread the handle into the hole (C)
in the miter gauge bar.
Insert the plate (D) (Inset) into the miter gauge slot (E) (Inset).
Slide the miter gauge on the saw table.
B Fig. 31
A
B
D
C
C
A
C
Fig. 34
14
A
C
Fig. 30
Fig. 32
D
Fig. 33
B
D
E