Removing The Hard Rubber Frame; Removing The Unit - Kenwood KRC-603C Instruction Manual

@ Removing the hard rubber frame
1 Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull tt forward as shown in the figure.
Accessory(4' Removal toot
2 When the lower level is removed, remove the upper two loca-
tions.
The frame can be removed from the top side in the same man-
ner.
@ Removing the Unit
1
2
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
Remove the Hex-head screw with integral washer (M4x8) on
the back panel.
Insert the two removal tools deeply into the slots on each side,
as shown.
Lower the removal tool
toward the bottom, and pull
out the unit halfway whilst
pressing towards the
inside.
Be careful to avoid injury from the catch pins on the removal tool.
5 Pull the unit all the way out
with your hands, being care-
ful not to drop it.
25