Integrated Peripherals - TYAN Tiger 230T S2507T User Manual

Table of Contents

Advertisement

(continued from previous page)
PCI Master 0 WS Write
PCI Delay Transaction
PCI#2 Access #1 Retry
AGP Master 1 WS Write / Read
Memory Parity / ECC Check

3.5 Integrated Peripherals

This section describes settings for the integrated peripherals setup options.
On-Chip IDE Channel 0 / 1
IDE Prefetch Mode
IDE Pri/Sec Master/Slave PIO
IDE Pri/Sec Master/Slave UDMA
Init Display First
IDE HDD Block Mode
Onboard FDD Controller
Onboard Serial Port 1 / 2
UART2 Duplex Mode
IR Function*
Tx,Rx Inverting Enabled*
(continued on next page)
* optional feature available on some Tiger 230T models.
36
Sets whether writes to PCI bus are executed with zero wait
states. [Default settings are Enabled]
Sets write buffer support in compliance with PCi spec v2.1.
[Default setting is Enabled]
Sets whether PCI masters should rotate priority [Default is Dis-
abled]
Sets whether one clock tick should be added to AGP write oper-
ations. [Default is Enabled]
Sets whether the BIOS should enable memory checking auto-
matically when it detects ECC DRAM. [Default is Disabled]
Sets the onboard support for the two IDE channels. [Default set-
ting is Enabled]
Sets support for IDE prefetching for faster drive accesses.
[Default setting is Enabled]
Sets PIO mode for each of up to four IDE devices that the
onboard IDE interface supports. [Default is Auto]
Sets whether UDMA data transfer protocol should transfer at
optimal speed, or to auto-detect optimal speed. [Default is Auto]
Sets type of display adapter installed. [Default is PCI Slot]
Sets onboard detection of optimal number of block R/W's per
sector that the drive can support. [Default is Enabled]
Sets whether onboard floppy controller should be used. [Default
is Enabled]
Sets logical COM port address and corresponding interrupt for
1st and 2nd serial ports. IR is offered on 2nd port. [Default is
Auto]
Sets whether COM port should be able to receive and transmit
data simultaneously. [Default is Half, as in Half-Duplex]
Option for IR mode setting (optional). [Default is No, Yes]
Reserved (optional). [Default is No, Yes]
http://www.tyan.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tiger 230tS2507t

Table of Contents