Installation And Setup (For The Network Connected Models) - Kyocera KM-F1060 Operating Instructions Manual

Installation and Setup (For the Network Connected Models)

For the Network Connected Models
Document Fax uses the fax modem in the Kyoceramita models connected on your network (LAN) for fax
communication.
Before using the Document Fax, it is necessary to activate the Fax Modem and to setup certain
parameters. Follow the steps below to setup the Document Fax.
Installation
1 Confirm the following device settings.
Send Only System settings:
Connection to the network
Set Internet parameters:
- IP Address
- Subnet Mask
- Default Gateway IP Address
- Relay XMT Password
Set Fax Parameters:
- Set the Relay XMT Report = Off (Fax Parameter No. 143. See the Operating Instructions for Facsimile and
Send & Receive System settings:
Connection to the network
Set Internet parameters:
- IP Address
- Subnet Mask
- Default Gateway IP Address
- Email Address
- Email Server Name/IP Address
- Relay XMT Password
Set Fax Parameters:
- Set the Relay XMT Report = Always (Fax Parameter No. 143. See the Operating Instructions for Facsimile
- Set the Fax Forward to Receive Email Account (Fax Parameter No. 054. See the Operating Instructions for
2 Install the Document Management System.
Refer to the Installation section of this Operating Instructions.
154
Internet Fax/Email)
and Internet Fax/Email)
Facsimile and Internet Fax/Email)