Adding And Registering Handsets; To Register A Handset To Your Telephone Base - AT&T CL84100 User Manual

Appendix

Adding and registering handsets

When first purchased, all expansion handsets alternately show 1.Press HS
LOC on base 4sec and
2.Then press # on handset on the screen. The new handset should be
charged without interruption for
at least 30 minutes before registering it to the telephone base.

To register a handset to your telephone base

1. Make sure the handset is out of the charger and
alternately shows 1.Press HS LOC on base 4sec
and 2.Then press # on handset before you begin
registration.
2. Press and hold
for about four seconds until the base screen shows
Registering handset..., then release the button.
3. Press # (pound key) on the handset. The screen
shows Registering... Please wait. It takes up to
60 seconds to complete registration. Then
HANDSET X Registered appears on the screen, with
X being the handset number (1-12), and the handset
beeps. The handset is now registered with the
telephone base.
If registration is not successful, the handset screen
displays Registration failed. Please start again from
step one above.
NOTES:
1. You cannot register a handset if any other system handset is in use.
2. You cannot register more than 12 handsets to the telephone base.
Registration slots are full shows on the base screen while you
are doing step two above.
LOCATOR on the telephone base
69
1.Press HS LOC
on base 4sec
2.Then press #
on handset
Registering
handset...
Registering...
Please wait
HANDSET X
Registered
HANDSET X
Registered