Table of Contents
Advertisement
Note: If you have just plugged the power cords of your server into an electrical
Installing the top cover and bezel
Before you install the server top cover and bezel, review the information in "Before
you begin" on page 39, "Handling static-sensitive devices" on page 40, and "Safety
information" on page 167.
Installing the top cover (all models)
Complete the following steps to install the server top cover:
1. Check that all cables, adapters, and other components are installed and seated
2. Move the cover-release latch to the open (up) position.
3. Insert the bottom tabs of the cover into the matching slots in the server chassis.
4. Close the cover-release latch to pull the cover forward and lock the cover in
5. If you disconnected any cables from the back of the server, reconnect the
outlet, you will have to wait approximately 20 seconds before pressing the
power-control button.
correctly and that you have not left loose tools or parts inside the server.
Top cover
Cover-release
latch
place.
cables; then, plug the power cords into properly grounded electrical outlets.
Note: If necessary, see "Input/output connectors" on page 108 for connector
locations.
Chapter 4. Customer replaceable units
105
Advertisement
Table of Contents
