Removing The Bezel (Tower Model) - IBM XSERIES 255 TYPE 8685 Hardware Maintenance Manual And Troubleshooting Manual

1. Review the information in "Before you begin" on page 39, "Handling
2. Press on the two release latches at the top edge of the bezel, and pull the top
3. Lift the bezel to release the two tabs at the bottom edge of the bezel.
4. Store the bezel in a safe place.

Removing the bezel (tower model)

Before you can access the controls on the front of a tower model server or install
any internal drives in a tower model server, you must first remove the bezel.
Complete the following steps to remove the tower model bezel.
1. Unlock the bezel, if it has not already been unlocked.
2. Press on the two release latches at the top edge of the bezel, and pull the top
50
xSeries 255 Type 8685: Hardware Maintenance Manual and Troubleshooting Guide
static-sensitive devices" on page 40, and "Safety information" on page 167.
of the bezel slightly away from the server.
Lock
of the bezel slightly away from the server.