Table of Contents
Advertisement
Removing the top cover and bezel
The following procedures show how to remove the top cover and bezel or door from
your server.
Removing the top cover (all models)
Complete the following steps to remove the server top cover.
1. Review the information in "Before you begin" on page 39, "Handling
2. Lift the plastic cover-release latch near the edge of the top cover.
3. Slide the top cover slightly toward the rear of the server; the cover will stop after
Removing the bezel (rack model)
Before you can install any removable-media drives in a rack model server, you must
first remove the bezel.
Complete the following steps to remove the rack model bezel.
static-sensitive devices" on page 40, and "Safety information" on page 167.
moving approximately 25 mm (1 inch). Lift the cover off the server, and set the
cover aside.
Attention:
To maintain proper cooling and airflow, install the server cover
before turning on the server. Operating the server for extended periods of time
(over 30 minutes) with the server cover removed might damage server
components.
Chapter 4. Customer replaceable units
49
Advertisement
Table of Contents
