Completing The Installation; Installing The Server Top Cover And Bezel - IBM Netfinity 6000R User Reference Manual

Completing the installation

Installing the server top cover and bezel

To complete your installation, you must reinstall the top cover, reinstall the bezel,
reconnect all the cables that you disconnected earlier and, for certain options, run the
Configuration/Setup Utility program. Follow the instructions in this section.
Attention: To maintain proper cooling and airflow, install the top cover before
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the top cover removed might damage server components.
Note: If you have just plugged the power cords of your server into an electrical
outlet, you will have to wait approximately 20 seconds before pressing the
power-control button.
The following illustration shows how to install the server top cover and bezel.
Note: The illustrations in this document might differ slightly from your hardware.
Cover release latch
Release latch
To install the server top cover:
1. Before installing the cover, check that all cables, adapters, and other components
are installed and seated correctly and that you have not left loose tools or parts
inside the server.
2. Place the cover-release latch in the open (up) position.
3. Insert the bottom tabs of the top cover in the matching slots in the server chassis.
4. Close the cover-release latch to pull the top cover forward and lock the top cover
in place.
5. If you disconnected any cables from the back of the server, reconnect the cables;
then, plug the power cords into properly grounded electrical outlets.
If necessary, refer to "Input/Output ports" on page 102 for connector
Note:
locations.
To install the bezel:
1. Insert the two tabs on the bottom of the bezel into the matching holes on the
server chassis.
2. Push the top of the bezel toward the server until the two tabs at the top of the
bezel snap into place.
Top cover
Release latch
Bezel
Chapter 6. Installing options
101