IBM INTELLISTATION E PRO 6204 User Manual page 64

10. Slide the drive into the drive bay, and then attach the drive to the drive cage.
11. Connect one end of the diskette or IDE signal cable into the back of the drive and
12. Connect the power cable to the back of the drive. The connectors are keyed and
13. If you have other options to install or remove, do so now.
14. Replace the cover. See "Replacing the cover" on page 53 for details.
15. Reconnect the external cables and power cords; then turn on the attached
Installing a hard disk drive: To replace a hard disk drive in the desktop model
computer, do the following:
1. Read the information in "Preinstallation steps" on page 47.
2. Turn off the computer and attached devices and disconnect the external cables
3. Remove the cover and frame support bracket. See "Removing the cover" on
4. Disconnect the power and signal cables from both drives in the drive cage.
48
IBM® IntelliStation® E Pro: User's Guide
the other end of the cable into the diskette or IDE connector on the system board.
For the location of the diskette or IDE connectors, see "System board internal
cable connectors" on page 40.
Note: Make sure to route the signal cable so that it does not block the air flow to
the rear of the drives or over the microprocessor.
can be inserted only one way.
devices and the computer.
and power cords.
page 41 and "Removing the frame support bracket" on page 42 for details.