IBM INTELLISTATION E PRO 6204 User Manual page 116

Table 14. NetWare driver messages for the Ethernet controller.
Message
Failed to create AFT group. Make
sure that the drivers for supported
adapters are loaded, primary
adapter is bound to protocols, and
secondary adapter is not bound to
any protocols.
Error identifying slot numbers for
the specified board names.
Can't unbind specified slot from
AFT group. Make sure that the slot
you specified is for the primary
adapter in an AFT group.
LAN adapter at slot nnnn (Port
0xaa) failed to reset. Check the
state of the adapter.
AFT is not supported on this
version of NetWare.
Failed to allocate resources tags.
Please unload all LAN drivers
before unloading AFT.NLM.
NDIS 4.0 (Windows 2000 and XP) Event Viewer messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
Table 15. NDIS (Windows 2000 or Windows XP) Event Viewer messages for the Ethernet controller.
Error code
(hex)
0x00 Explanation: The driver could not register the specified interrupt.
Action: Contact your network administrator.
0x01 Explanation: One of the PCI adapters did not get the required resources.
Action: Contact your network administrator.
100
IBM® IntelliStation® E Pro: User's Guide
Explanation: Binding of protocol failed. Protocol is either not bound to any
adapter or is bound to more than one adapter in the group.
Action: Ensure that the protocol is bound to only one adapter in an AFT team.
Explanation: The mapping between the board name entered and the slot
number for an adapter could not be established.
Action: Check the board name for the adapter before issuing the bind command.
If the problem persists, contact your network administrator
Explanation: The number entered in the unbind command was not the primary
adapter in an AFT group.
Action: Reissue the unbind command and specify the slot number for the
primary adapter
Explanation: The adapter that you specified could not be initialized.
Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and try loading the AFT
module again.
If the problem persists, contact your network administrator.
Explanation: The NetWare on your computer is not a version supported by AFT.
Action: Load and bind AFT only on supported versions of NetWare (currently
version 4.11 and above).
Explanation: An unknown error has occurred when trying to allocate needed
resources for the AFT module.
Action: Check computer configuration. If the problem persists, contact your
network administrator.
Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter driver.
Action: Unload the adapter driver before unloading the AFT module.
Description
Description