Using The Recovery Repair Diskette; Using Configsafe And The Save Our System (Sos) Feature - IBM INTELLISTATION E PRO 6204 User Manual

Do the following to recover the operating system:
1. If you are recovering your software using a Product Recovery CD, insert the CD
2. If possible, shut down your operating system normally.
3. If your computer is still on, turn it off.
4. Turn on your computer. Wait for the prompt:
5. You might have a choice of operating systems to recover. Select the operating
6. Select the recovery options you want and follow the instructions on the screen.
7. When recovery is complete, exit from the program. If necessary, remove the CD
8. Restart the computer.

Using the Recovery Repair diskette

In some circumstances, files on your hard disk might become unusable so that the
F11 prompt is not displayed when you start up your computer. Using the following
procedure, you will be able to access the Product Recovery Program on the hard disk
drive.
1. Insert the Recovery Repair diskette.
2. Turn off your computer.
3. Turn on your computer, and follow the directions on the screen.
Note: If the repair operation finishes without error, the F11 prompt will be displayed
If an error message is displayed during the repair operation and the repair operation
cannot be completed, you might have a problem with the Product Recovery Program
or the partition that contains the Product Recovery Program. Use a Product Recovery
CD to access the Product Recovery Program. To obtain a Product Recovery CD,
contact IBM to order a Product Recovery CD for your computer. See "Getting
information, help, and service" on page 111 for details.

Using ConfigSafe and the Save Our System (SOS) feature

Before making any changes to your computer configuration, use ConfigSafe to take a
snapshot of your current operating system configuration. ConfigSafe automatically
takes a snapshot of your operating system configuration the first time you start your
Important
If you are recovering your operating system from a Product Recovery CD and
you have more than one CD, always start with Product Recovery CD 1.
into the CD-ROM or DVD-ROM drive. If you are using the Product Recovery
Program on the hard disk drive, continue to the next step.
Note: If the computer will not turn off after you hold down the power button for at
least four seconds, unplug the power cord and wait a few seconds before
reconnecting it.
Quickly press F11. The prompt displays for only a few seconds. Wait for the
program menu.
If the DOS command prompt or the F11 prompt is not displayed, See "Using the
Recovery Repair diskette".
system you want.
from the CD-ROM or DVD-ROM drive.
the next time you restart your computer.
Chapter 6. Solving problems
107