Adding Users
SMU allows a maximum of 13 users, including the three default users shown in
Table 2-1.
To add a user:
1. Select Manage > General Config > User Configuration > Add Users.
The Add System User panel displays the current list of configured users.
2. Type a new username.
The name is case sensitive and can include 19 characters. Allowed characters
include letters, numbers, hyphens, underscores, and spaces.
3. Type a password.
The password is case sensitive and can include # characters. Allowed characters
include letters, numbers, hyphens, underscores, and spaces.
4. Select an access level:
Monitor enables access to all functions on the Monitor menu.
■
Manage enables access to all functions on the Monitor and Manage menus.
■
5. Select a user type:
Standard enables access to most functions.
■
Advanced additionally enables access to infrequently used administrative
■
functions.
Diagnostic additionally enables access to troubleshooting functions for use by
■
service technicians.
6. Enable or disable the user's access to system interfaces:
WBI – The web-browser interface (SMU)
■
CLI – The command-line interface
■
FTP – The file transfer protocol interface
■
Note –
management service is enabled on the Manage > General Config > Services
Security page.
7. Click Add User.
The user is added to the Add System User panel.
34
HP StorageWorks 2000 Family Modular Smart Array reference guide • August 2008
A system interface can be used only if the corresponding network