Configuring The Debug Log - HP 2000fc Reference Manual

8. If prompted to specify the file location and name, do so using a
The default file name is
be sure to name the files appropriately so that they can be identified later.
Note –
automatically saved there.

Configuring the Debug Log

When instructed to do so by service personnel, as an Advanced Manage user you
can configure the debug log. The debug log captures data that will help service
personnel locate problems within the system logic.
After you configure the debug log as instructed, you will need to perform I/O to the
system or re-create the situation that is causing the fault. This populates the debug
log with information that service personnel can use to diagnose the system.
Note –
information about any problems that occurred before you configure it.
To configure the debug log:
1. Select Manage > Utilities > Debug Utilities > Debug Log Setup.
The Debug Log Setup page is displayed.
2. Select the debug log setup you want.
Standard – Used for diagnosing general problems. With minimal impact on I/O
■
performance, it collects a wide range of debug data.
I/O - Performance – Used for diagnosing I/O interface problems. Using this
■
option, the debug log is dedicated to collecting I/O interface information, with
minimal impact on I/O performance.
Device-Side – Used for diagnosing device-side problems. It collects device
■
failure data as well as I/O interface information, with minimal impact on I/O
performance.
Device Management – Collects very verbose information, including all
■
Configuration API (CAPI) transactions. Because this option collects a lot of data,
it has a substantial impact on performance and quickly fills up the debug trace.
224 HP StorageWorks 2000 Family Modular Smart Array reference guide • August 2008
store.logs
If you are using Firefox and have a download directory set, the file is
The debug log only collects data after you configure it. It will not contain
. If you intend to capture multiple event logs,
extension.
.logs