10 Management
This section details the VLS management procedures such as changing the account passwords,
managing high availability, and saving configuration settings.
Changing the Account Passwords
To change the administrator and/or user account password, from Command View VLS:
1.
Click the System tab.
2.
Select Chassis from the navigation tree.
3.
Click Edit Accounts under Maintenance Tasks. The Edit Accounts window opens.
4.
Enter the current password in the Old Password box. The password is case sensitive.
5.
Enter a new password in the New Password box.
6.
Enter the new password again in the Retype New Password box.
7.
Click Apply Settings.
Command View VLS restarts automatically.
NOTE:
You can change the user or administrator account password separately, or change both at
the same time.
NOTE:
The password can also be changed from the VLS CLI. See
Managing High Availability
This section describes the methods to maintain high availability with your VLS.
Array Dual Pathing
The VLS12000 Gateway supports dual pathing to the Gateway arrays, which provides path balancing
and transparent path failover on the VLS. Having followed the setup recommendations in the HP
StorageWorks VLS12000 Gateway virtual tape libraries solutions guide and the installation instructions
in this guide, each node on the VLS is connected to two fabrics/zones which are each connected to
the Gateway arrays by two or more paths. This assures that the VLS can establish two paths per LUN,
each path on a separate fabric/zone.
HP StorageWorks 12000 Gateway Virtual Library System User Guide
"CLI Management
commands" on page 175.
141