HP StorageWorks 12000 User Manual page 114

• Fully qualified host name (or host name and DNS domain name separately), DNS server address,
IP address, gateway, and netmask
To set the network settings using the CLI command set:
1. Open a serial session and log in to the administrator account. See
Session" on page 109.
2. To see the current configuration settings, at the prompt enter:
showConfig
3. Set each desired configuration value by entering:
setConfigValue <-tag> [value]
where <-tag> can be any of the following:
Tag
-host
-domain
-fullhost
-dnsaddr
-dnsaddr1
-dnsaddr2
-dhcp
-ipaddr
-gate
-mask
–ntpPrimary
—ntpSecondary
NOTE:
More than one network value can be set at a time or you can set them individually.
To reset a value, enter " " (quoted space) as the value.
NOTE:
If you need to clear the DNS completely, set the DHCP to false and enter 0.0.0.0 for
both the first and second DNS server addresses.
4. When all the network parameters are set to your desired values, save the settings by entering:
commitConfig
114 Configuration
Description
Host name (such as vlsexamp) (unqualified)
DNS domain name (such as xyz.com)
Fully qualified name (such as vlsexamp.xyz.com)
DNS server address (replaces all addresses with one line)
First DNS server address (cannot use with dnsaddr)
Second DNS server address (cannot use with dnsaddr)
Has no value, indicates you want to configure the public Ethernet connection
using DHCP (reset is -dhcp=false)
IP address of public Ethernet connection
Gateway to network (xx.xx.xx.x)
Netmask. Default is 255.255.255.0
First NTP Server Address
Second NTP Server Address
"Opening a Serial