Table of Contents
Advertisement
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by
pressing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace
Note: Do not leave the hand-held remote in
the AUTO mode close to the fireplace. The
radiant heat from the fireplace will turn off the
fireplace. Ideally, place the hand-held remote
in the center of the room facing towards the
fireplace.
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Safety Features
When away from home for an extended period
of time or as a child safety feature to prevent
accidental ignition of the fireplace, the receiver
ON/OFF/REMOTE switch should be in the
OFF position.
Auto Shutoff Feature
1. If the average room temperature reaches
a range of 82° F (28° C) to 92° F (33° C),
the hand-held remote control will perform
a safety override and shut the fireplace
off. This feature is not available in the
MANU mode.
2. The receiver continuously receives sig-
nals from the hand-held remote to control
the room temperature. If the hand-held
remote is misplaced, obstructed or for any
reason cannot transmit to the receiver, the
receiver will shut off the fireplace. This will
occur in 8 or more minutes depending
upon location of remote transmitter and
strength of batteries.
Key Pad Lock Feature
This feature allows the user to lock/unlock the
keypad on the hand-held remote in the MANU
or AUTO mode to prevent inadvertent op-
eration (i.e. children operating the hand-held
remote control, etc.). The keypad is locked in
either on or off. Press the POWER and LOCK
buttons together to turn the unit on or off.
22
OPERATION
Continued
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases
or Decreases Room
Temperature in
AUTO Mode
Figure 37 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Locate the blower switch by opening lower
louver on fireplace. Blower switch is located
at lower right inside louver door.
The GA3700T Series thermostat-controlled
blower has a variable speed control with an
ON/OFF switch. The blower will start when
the thermostat senses a sufficient increase in
firebox temperature. The GA3700 series vari-
able speed blower also has an ON/OFF switch
built into the variable speed control.
Note for GA3700T Series Only: If you are us-
ing GA3700T blower, your fireplace and blow-
er will not turn on and off at the same time.
The fireplace may run for several minutes
before the blower turns on. After the heater
modulates to the pilot position, the blower will
continue to run. The blower will shut off after
the firebox temperature decreases.
Note: It is safe to operate fireplace with blower
turned off. However, the blower helps distrib-
ute heated air from the fireplace.
Follow installation instructions included with
the blower accessory.
www.desatech.com
Digital Display Shows
Temperature and Settings
AUTO
ROOM
SET
TEMP
TEMP
TEMP
LOCK
POWER
MANU
AUTO
ºC/ºF
°C/°F Mode
Button
OpTIONAL BLOWER
OpERATION
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
113109-01G
Hide quick links:
Advertisement
Table of Contents
