Desa GA3700 Owner's Operation And Installation Manual page 18

Notches
Screws for
Mounting Screen
Figure 26 - Installing Fireplace Screen
OpTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
(HRC100 and HRC200)
Installing Remote Receiver Unit
1. Disconnect switch wires from the con-
trol valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 27).
Discard after removing.
4. Install remote receiver unit onto gas log
heater base using mounting clips.
5. Push clips firmly into place (see Figure 28).
6. Connect wires as shown in Figure 29.
Remote
Switch
Bracket
Screw
Switch Plate
Figure 27 - Switch Plate and Wiring
Harness
18
INSTALLATION
Continued
Ignitor
Wires
www.desatech.com
Mounting
Clips
Remote Receiver
Figure 28 - Installing Remote Receiver
White Wire
From Receiver
Figure 29 - Connecting Wires
INSTALLING 9-vOLT BATTERIES
Two 9-volt batteries (not included) are re-
quired to operate this heater with the wireless
hand held remote control set. Install one bat-
tery in the receiver and one in the hand-held
remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner
of heater.
2. Locate the battery clip mounted on the
back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Remote
Receiver
9-Volt Battery
Figure 30 - Installing Battery in Remote
Receiver
Valve
Red Wire From
Receiver
Terminal Wires
Battery Clip
113109-01G