Table of Contents
Advertisement
LOCAL CODES
Install and use log set with care. Follow all
local codes. In the absence of local codes,
use the latest edition of The National Fuel
Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Burner Manifold
Grate
f i r e - p a r t s . c o m
Burner
Pan
Left Side
Burner
ON/OFF SAFETY VALVE/PILOT kIT
AND PROPANE/LP CONVERSION
An optional valve/safety pilot kit with a piezo
ignitor is available for this appliance. This sys-
tem requires no matches, batteries or other
sources to light. You must use this optional
system for LP conversion. See Accessories,
page 22.
REMOTE CONTROL READY
(MILLIvOLT) SAFETy vALvE/PILOT KIT
An optional millivolt valve/safety pilot kit with
a piezo ignitor is available for this appliance.
This system requires no matches, batteries
or other sources to light. This system may
be connected to a wall switch or hand-held
wireless remote control. See Accessories,
page 22.
4
PRODUCT IDENTIFICATION
Right Side
Burner
Burner Inlet
Fitting
Figure 1 - Product Identification
OPTIONAL PRODUCT FEATURES
www.desatech.com
UNPACkING
CAUTION: Do not remove
the data plates from the burner
pan. The data plates contain
important warranty and safety
information.
1. Remove logs, hearth kit, pan materials
and hardware from carton.
2. Remove all protective packaging applied
to logs and base for shipment.
3. Check heater for any shipping damage.
If heater is damaged call DESA Heating,
LLC at 1-866-672-6040 for replacement
parts before returning to dealer.
Hearth Kit Model: ____________________
Serial Number: ______________________
Log Set Model: _____________________
REMOTE CONTROL ACCESSORIES
There is an optional hand-held ON/OFF re-
mote control that can be purchased separately
for this log set. You must use the millivolt
valve/safety pilot kit to use remote acces-
sories with this appliance. See Accessories,
page 22.
A wall switch is also available for this appli-
ance. You must use the millivolt valve/safety
pilot kit to use the wall switch with this appli-
ance. See Accessories, page 22.
901267-01E
Advertisement
Table of Contents
