Bernina Serger 1150MDA Owner's Workbook page 38

Seaming Knit Fabrics:
Presser Foot Pressure
Fabric .................................................. 2 pieces cotton single knit jersey,
................................................... each 3" x 6" with stretch across 3" side
Needle .............................................................. 75/11 Stretch or Ballpoint
Thread ............................................... 2 cones of serger thread (needles)
......................................................... 2 cones YLI Woolly Nylon (loopers)
Presser Foot .............................................................................. standard
Stitch ............................................................................ 4-thread overlock
Thread the serger for a 4-thread overlock stitch, using regular serger
thread in the needles and Woolly Nylon in the loopers.
Set all thread tensions at usual 4-thread overlock settings.
Using a fabric marker, divide the fabric in half along a 6" side.
With right sides together and a ¼" seam allowance, serge to the mark on
the fabric.
Without removing the fabric from under the presser foot, notice the
"ripple" effect where the fabric has stretched.
Reduce the presser foot pressure to low.
Seam the jersey to the end of the fabric.
Remove the fabric from under the presser foot and observe the de-
creased "rippling".
Return the presser foot pressure adjusting lever its normal setting.
Trim and mount the sample.
Record settings in chart below:
BERNINA
M Y
ASTERING OUR
Permission to copy and distribute in printed and electronic formats granted only to Authorized BERNINA
Sergers
®
S 6/2006
ERGERS
©2006 BERNINA ® of America, Inc.
Mastering
Your
BERNINA
®
Notes
38
®
Dealers