Bernina Serger 1150MDA Owner's Workbook page 106

Mastering
Sergers
Your
BERNINA
®
Two-Thread Wrapped Edge
Fabric ................................................. heavy wool or polar fleece, 5" x 6"
Notes
Needle ............................................................................. 80/12 Universal
Thread ..................................................................... 1 cone serger thread
............................................................................1 cone YLI Jeans Stitch
Presser Foot .............................................................................. standard
Stitch .......................... wide 2-thread wrapped edge (left or right needle)
Attach the Upper Looper Converter) to the upper looper.
Note: This is an optional accessory for the 700D.
Following the instructions in your owner's manual' thread the serger
for a 2-thread wrapped edge using Jeans Stitch in the lower looper.
Adjust settings as indicated.
Place the fabric under the presser foot and serge along one edge; adjust
the differential feed if needed.
If the Jeans Stitch does not wrap around the edge completely, the thread
tension may be too tight. Reduce the looper thread tension.
If the thread still does not wrap, remove the Jeans Stitch thread from the
uppermost thread guide and try again.
Wrap-stitch the other three edges of the fabric.
Use seam sealant to seal the stitching at the corners. When the
sealant is dry, trim the thread tails.
Return stitch length and thread tension levers to normal.
Trim and mount the sample.
BERNINA
®
M Y S 6/2006 106
ASTERING OUR ERGERS
©2006 BERNINA ® of America, Inc.
®
Permission to copy and distribute in printed and electronic formats granted only to Authorized BERNINA Dealers