Configuring Ap Inputs - Bosch DB18C3100R2 Installation Manual

82 en | Default Configuration
6.5.7

Configuring AP Inputs

Inputs and outputs menu > AP inputs tab
If an AP is connected serially, a maximum of 32 inputs that can cause triggering of an alarm in
the system can be specified.
As standard, every input has line statuses assigned that can be modified in LSN alarm panels
for the specific project. In addition, AP addresses can be assigned to each input.
1
2
3
4
F.01U.033.308 | V7 | 2009.09
AP inputs
Connection settings
Interface:
Baud rate:
AP type:
Type
Name
Installation Guide
Click the tab.
Select the interface.
Select the Baud rate.
Select the AP type.
Click the down arrow in the column and select the
type of input.
The input type, e.g. holdup, is activated.
The input type is not activated.
Note:
Each input has specific types of line statuses
assigned as standard. This assignment can be
changed for LSN alarm panels.
Place the cursor in the column and enter the name.
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH