Control Inputs - Bosch PRAESENSA Manual

78 en | Installation wiring
3.7.11

Control inputs

The multifunction power supply provides eight control inputs on a 16‑pole connector.
In case no interconnection supervision is configured, just use a switch or a relay output from
another system for activation.
Connection procedure
1.
2.
3.
Notice!
i
Do not use any terminal in common with other control input terminals.
2021.12.21 | V0.15b | F.01U.402.882
E
12
Use a 2‑wire cable, proper for the installation, and the 16‑pole terminal plug (E) delivered
with the device.
Insert the near end wires of the cable into the appropriate slots of terminal plug (E),
preferably using crimped on wire ferrules that fit to the wire gauge used.
– Use a flat blade screw driver to tighten each connection.
Connect the other side of the cable to the activation switch or voltage free relay contact.
Underwriters Laboratories Listing Document (ULLD)
1-8
PRAESENSA
Bosch Security Systems B.V.