Cisco QuickVPN - PC Administration Manual page 135

Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the Administration Settings
STEP 1
STEP 2
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
To configure System Logs for the router, follow these steps:
Click Administration > Log.
Configure the system logs for the router:
• Log Setting
- Log Level—Select the log levels that the router should record.
Level Severity Name
7 LOG_DEBUG
6 LOG_INFO
5 LOG_NOTICE
4 LOG_WARNING
3 LOG_ERR
2 LOG_CRIT
1 LOG_ALERT
0 LOG_EMERG
- Outgoing Log—Select Enable to cause all outgoing packets to be
logged. You can then click View Outgoing Table to display information on
the outgoing packets including Source IP, Destination IP, and Service/Port
number.
- Incoming Log—Select Enable to cause all incoming packets to be
logged. You can then click View Incoming Table to display information on
incoming packets including Source IP, Destination IP, and Service/Port
number.
• Email Alerts
- Email Alerts—If enabled, an e-mail is sent when the number of DoS
events exceeds the defined threshold or the total events number exceed
100. If enabled, you must provide the e-mail address information.
Description
Debug-level message
Information messages only
Normal but significant condition
Warning conditions
Error conditions
Critical conditions
Immediate action needed
System unusable
5
135