Table of Contents
Advertisement
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
WARNING: Failure to position the parts in accor-
dance with supplied diagrams or failure to use only
parts specifically approved with this stove and burner
system may result in damage or personal injury.
8.
Connect or reconnect gas supply to stove and burner system
per Connecting Stove/Burner System to Gas Supply on page
20 of this manual.
WARNING: A qualified service person must con-
nect burner system to gas supply. Follow all local
codes.
INSTALLING REAR COVER
1.
Lift rear panel over vent pipe connection on burner system.
Rear cover will rest on the bottom ledge of the stove body.
2.
Using screws provided, attach rear cover to back of stove body.
See Figure 17.
IMPORTANT: This rear cover must be securely in place be-
fore venting pipes are installed.
Rear
Cover
Figure 17 - Installing Rear Cover
For more information, visit www.desatech.com
For more information, visit www.desatech.com
105501-01F
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Screw
Burner System
Installed In Cast
Iron Stove Body
Installing Optional Blower Accessory (Cont.)
Location Of Vent Termination
GENERAL VENTING
These models are approved for use with Simpson Dura-Vent 6
direct-vent pipe components and terminations as well as both flex
and rigid Comfort Glow vent components.
Your stove with burner system is approved to be vented either
through the side wall, or vertically using the following guidelines:
• Only use Comfort Glow or Simpson Dura-Vent GS venting com-
ponents or kits specifically approved for this stove and burner
system.
• Minimum clearance between vent pipes and combustible mate-
rials is 1" (25 mm), except where stated otherwise.
• Do not recess venting terminals into a wall or siding.
• Install horizontal venting with a 1/4" rise for every 12" of run
toward the termination.
• You may paint the vent terminal with 450ºF (232ºC) heat-resis-
tant paint to coordinate with the exterior finish.
• There must not be any obstruction such as bushes, garden sheds,
fences, decks, or utility buildings within 24" from the front of
the termination cap.
• Do not locate termination cap where excessive snow or ice build
up may occur. Be sure to clear vent termination area after snow
falls to prevent accidental blockage of venting system. When
using snow blowers, do not direct snow towards vent termina-
tion area.
• You must maintain minimum wall and ceiling clearances shown
in Figures 3 and 4, page 5.
LOCATION OF VENT TERMINATION
When locating vent termination, it is important to observe the
minimum clearances shown in Figure 18, page 10.
*Check with local codes or with the current CAN/CGA B149[.1 or
.2] Installation Codes for Canada or the USA Installations follow
the current National Fuel Gas Code, ANSI Z223.1/NFPA 54.
Installing Rear Cover
GENERAL VENTING
9 9
5
/
"
8
Advertisement
Table of Contents
