Desa CDVBPC Operation And Installation Manual page 7

CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
10. Attach stove door by inserting step bolt through door hinge
pivot hole and into threaded hole in stove body (see Figures 9
and 10, page 6). Use an adjustable wrench or a 12mm socket
to fasten step bolt. Tighten step bolt until snug. Make sure door
moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 9, page 6).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 13). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make fi-
nal adjustment and door leveling after stove is in normal stand-
ing position.
13. Carefully lift stove back up on its four attached legs.
14. Set top grate into stove top.
Washers
Bolt
Figure 11 - Attaching Stove Bottom
Stove
Door
Door
Hinge
Step Bolt
Bolt Shoulder
Figure 12 - Attaching Stove Door
For more information, visit www.desatech.com
For more information, visit www.desatech.com
105501-01F
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Bottom Of
Stove Unit
Stove Bottom
Threaded
Hole
Stove Bottom
Stove Body Assembly (Cont.)
Installing Direct-Vent Burner System Into Stove Body
Door Claw
Door
Figure 13 - Catch Bolt and Door Claw Orientation
INSTALLING DIRECT-VENT BURNER
SYSTEM INTO STOVE BODY
1. Carefully lift burner system and place into stove body from
the rear of stove.
2. Using screws provided, attach burner system to back of stove.
Burner
System
Cast Iron
Stove Body
Figure 14 - Installing Burner System Into Cast Iron Stove Body
7 7
Bolt Stop
Adjusting Nut
Catch Bolt
Screw